Updating imac g3 Amaturedating
Here are the steps: Another option is to use an external Fire Wire enclosure for formatting/partitioning the receiver drive and cloning your disk image to it.Using this process, you can create a bootable OS X drive for a tray-loading i Mac, beige G3, or Wall Street Power Book without ever touching XPost Facto.Slow, low-cost hard drives that may have 8-9 years on them by now.Hard drives that may not be big enough for Mac OS X 10.4 "Tiger".One of Bill's tricks is to do the entire Mac OS installation in another computer, one that supports two internal hard drives.You can use a Blue & White Power Mac G3 or any Power Mac G4, as the drop down door makes access to drives fast and easy.
It's not an issue for SCSI drives or IDE/Ultra ATA drives on a PCI controller card - neither of which is an option for the i Mac.) Bill's solution, which I wholeheartedly support, is to dispense with trying to create the largest possible boot partition and just make it 7 GB (or perhaps a little larger).(You can't boot from a CD to do a firmware update; you have to boot from a hard drive.) Be sure the firmware update has taken before upgrading your Mac OS installation, as you can otherwise end up with a Mac that won't boot with the OS you've just installed.Another tip from Bill: If you do end up with an unbootable tray-loading i Mac and have access to another i Mac that's working just fine with the version of the Mac OS you installed, swap out the little daughtercard CPU modules.Bill has found that our number is too high: Partitioning at 7.45 GB or even 7.38 GB results in unbootable OS X installations.I've found the same thing when working with a Beige G3.
You can install the classic Mac OS and Mac OS X through version 10.3 from CD, which is the only kind of optical drive Apple ever built into the tray-loading i Macs and the 350 MHz slot-loading i Mac.